Hi3516a的sd卡识别失败的问题

各位大神好，使用Hi3516A的时候遇到了这个问题，查了好几天都没结果，不知道各位有啥建议不？
我使用的是microsd 16G的卡，之前用一个2g的普通卡是正常的

SD卡初始化的时候在host端设置sd_set_bus_speed_mode时候显示设置出现了问题，这个速度是host端在识别总线上的sd卡后查询到SD卡支持的最大速度，在根据host端支持的最大速度，最后协商出一个速度，不知道为啥设置会失败？

VFP support v0.3: implementor 41 architecture 2 part 30 variant 7 rev 5
mmc0: Problem setting bus speed mode!
sd_set_bus_speed_mode: sd_bus_speed 1 status16:16!
mmc0: new ultra high speed SDR25 SDHC card at address aaaa
mmcblk0: mmc0:aaaa  14.8 GiB
mmcblk0: error -110 sending status command, retrying
mmcblk0: error -110 sending stop command, original cmd response 0x900, card status 0x800b00
mmcblk0: error -84 transferring data, sector 0, nr 8, cmd response 0x900, card status 0xb00
mmcblk0: retrying using single block read
mmcblk0: error -22 sending status command, retrying
mmcblk0: error -22 sending status command, retrying
mmcblk0: error -22 sending status command, aborting
end_request: I/O error, dev mmcblk0, sector 0
Buffer I/O error on device mmcblk0, logical block 0
mmcblk0: error -22 sending status command, retrying
mmcblk0: error -22 sending status command, retrying
mmcblk0: error -22 sending status command, aborting
end_request: I/O error, dev mmcblk0, sector 0