求高人教将雄迈hi3520d板子烧写系统【已解决】

本帖最后由 fb362203 于 2016-11-2 22:00 编辑

哪位大神已经将雄迈板子成功烧写系统的，求教

买了块雄迈的h3520D板子AHB-7804T-LMS，焊接好串口，发现串口不能输入，一直显示在
Starting kernel ...

Uncompressing Linux... done, booting the kernel.
不能动了，有没有telnet或者ssh，不知道该怎么办了，求用过的人教下该怎么刷系统，或者终端输入。感激不尽，懵在这里不知道咋办了


U-Boot 2010.06-svn198 (Dec 08 2014 - 13:02:43)

Check spi flash controller v350... Found
Spi(cs1) ID: 0xC2 0x20 0x17 0xC2 0x20 0x17
Spi(cs1): Block:64KB Chip:8MB Name:"MX25L6406E"
envcrc 0xec4d696a
ENV_SIZE = 0xfffc
In:    serial
Out:   serial
Err:   serial
USB:   scanning bus for devices... 1 USB Device(s) found
0 Storage Device(s) found
Press CTRL-C to abort autoboot in 0 seconds8192 KiB hi_sfc at 0:0 is now current device

CFG_BOOT_ADDR:0x0
0ff:0x84000000
### /UbootLogo UbootLogoload complete: 21986 bytes loaded to 0x8e800000
jpeg decoding ...
<>
<>
decode success!!!!
decode jpeg success.
decode jpeg!

srcAddr 0x82000000, dstAddr 0x82000000
find_squashfs_file: name bin, start_block 0, offset 1346, type 1
find_squashfs_file: name boot, start_block 0, offset 1434, type 1
read inode: name boot, sb 0, of 1434, type 1
find_squashfs_file: name zImage.img, start_block 0, offset 1378, type 2
read inode: name zImage.img, sb 0, of 1378, type 2
### FS load complete: 1434688 bytes loaded to 0x82000000
## Booting kernel from Legacy Image at 82000000 ...
   Image Name:   linux
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1434624 Bytes = 1.4 MiB
   Load Address: 80008000
   Entry Point:  80008000
   Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
这是全部的logo信息，输入ctrl+c也没见有反应啊


终于案成功了ctrl c