新方案3516CV+8G EMMC 分区问题

本帖最后由 xxianqi 于 2017-8-13 20:09 编辑

新方案
3516CV200+8G EMMC
用HITOOL的4.0.16程序EMMC全清除选项没有用。显示FASTBOOT下载完成，
但是不能启动(注：IC选的HI3518EV200，因为里面没有HI3516CV200)

用HITOOL下载1.0.30的SDK里的3516CV200程序代码。出现如下问题。不知道
那二个BOOT0跟BOOT1怎么清除。


mmcblk0: mmc0:0001 H8G1e 7.28 GiB
mmcblk0boot0: mmc0:0001 H8G1e partition 1 4.00 MiB
mmcblk0boot1: mmc0:0001 H8G1e partition 2 4.00 MiB
mmcblk0: p1(boot) p2(kernel) p3(rootfs) p4(test)
mmcblk0boot1: unknown partition table
mmcblk0boot0: unknown partition table
mmcblk0: response CRC error sending r/w cmd command, card status 0x900
mmcblk0: error -84 sending status command, retrying
mmcblk0: error -84 sending status command, retrying
mmcblk0: error -84 sending status command, aborting
himci: <6>hi_mci_execute_tuning:1465:
himci: mmc0: no valid phase shift! use default
himci:
mmcblk0: error -84 sending status command, retrying
mmcblk0: error -84 sending status command, retrying
mmcblk0: error -84 sending status command, aborting
end_request: I/O error, dev mmcblk0, sector 8192
Buffer I/O error on device mmcblk0p3, logical block 0
lost page write due to I/O error on mmcblk0p3
EXT4-fs (mmcblk0p3): mounted filesystem with ordered data mode. Opts: (null)
VFS: Mounted root (ext4 filesystem) on device 179:3.
Freeing init memory: 132K
mmcblk0: error -84 sending status command, retrying
mmcblk0: error -84 sending status command, retrying
mmcblk0: error -84 sending status command, aborting
himci: <6>hi_mci_execute_tuning:1465:
himci: mmc0: no valid phase shift! use default