在配置Uboot后提示模式无效

hisilicon # ping 192.168.1.56

配置完uboot，重新烧录，之后ping一次就重启，提示模式没有配置，但是使用setenv配置无效，请问这个具体的配置在哪里呢，uboot配置里吗

Invalid speed(1) & interface(3) mode.
Please assign which mode our eth will correctly work at.
It may support 10M/100M MII, 10M/100M RMII, 10M/100M/1000M RGMII interface.
eg. if your board have two NICs, connecting each phy using mii and rgmii interface, you can use the module param 'port_mode=mii,rgmii' to tell the driver.
BUG: failure at higmac.c:91/calculate_port_mode()!
BUG!
resetting ...


System startup

U-Boot 2010.06 (Aug 17 2020 - 17:30:58)

Check Flash Memory Controller v100 ... Found
SPI Nor(cs 0) ID: 0xc2 0x20 0x19
Block:64KB Chip:32MB Name:"MX25L(256/257)XX"
SPI Nor total size: 32MB
Check Nand Flash Controller v610 ... found
Special NAND id table Version 1.38
hinfc610.c(591): Wait NAND controller finish timeout.
hinfc610.c(526): Wait NAND controller finish timeout.
Cannot found a valid Nand Device
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  0 
Wrong Image Format for bootm command
ERROR: can't get kernel image!