3559v200 编码

3559v200 用一个rt8152b usb转网口，平常网络都正常，在编码程序运行后网络就会出问题，主要是这个函数HI_MPI_VENC_CreateChn运行后就会出问题，有没有遇到的。
打印如下：
xhci-hcd 100e0000.xhci_0: xHCI host not responding to stop endpoint command.
xhci-hcd 100e0000.xhci_0: Assuming host is dying, halting host.
xhci-hcd 100e0000.xhci_0: HC died; cleaning up
usb 1-1: USB disconnect, device number 2
——————[ cut here ]——————
WARNING: CPU: 1 PID: 61 at fs/sysfs/group.c:237 sysfs_remove_group+0x94/0x9c
sysfs group ‘rtl_adv’ not found for kobject ‘1-1:1.0’
Modules linked in: hi_mipi_rx(O) hi3559v200_acodec(PO) hi3559v200_adec(PO) hi3559v200_aenc(PO) hi3559v200_ao(PO) hi3559v200_ai(PO) hi3559v200_aio(PO) hi3559v200_hdmi(PO) hi_sensor_spi(O) hi_sensor_i2c(O) hi_piris(O) hi_pwm(O) hi3559v200_nnie(PO) hi3559v200_ive(PO) hi3559v200_vdec(PO) hi3559v200_vfmw(PO) hi3559v200_jpegd(PO) hi3559v200_jpege(PO) hi3559v200_h265e(PO) hi3559v200_h264e(PO) hi3559v200_venc(PO) hi3559v200_rc(PO) hi3559v200_vedu(PO) hi3559v200_chnl(PO) hifb(O) hi3559v200_vo(PO) hi3559v200_vpss(PO) hi3559v200_isp(PO) hi3559v200_vi(PO) hi3559v200_dis(PO) hi3559v200_vgs(PO) hi3559v200_gdc(PO) hi3559v200_rgn(PO) hi3559v200_tde(PO) hi3559v200_sys(PO) hi3559v200_base(PO) sys_config(O) hi_osal(O)
CPU: 1 PID: 61 Comm: kworker/1:1 Tainted: P O 4.9.37 #5
Hardware name: Generic DT based system
Workqueue: usb_hub_wq hub_event
[] (unwind_backtrace) from [] (show_stack+0x10/0x14)
[] (show_stack) from [] (dump_stack+0x84/0x98)
[] (dump_stack) from [] (warn+0xe8/0x100)
[] (warn) from [] (warn_slowpath_fmt+0x4c/0x78)
[] (warn_slowpath_fmt) from [] (sysfs_remove_group+0x94/0x9c)
[] (sysfs_remove_group) from [] (rtl8152_disconnect+0x18/0x88)
[] (rtl8152_disconnect) from [] (usb_unbind_interface+0x7c/0x298)
[] (usb_unbind_interface) from [] (device_release_driver+0x88/0x124)
[] (device_release_driver) from [] (device_release_driver+0x1c/0x28)
[] (device_release_driver) from [] (bus_remove_device+0xd8/0x104)
[] (bus_remove_device) from [] (device_del+0x120/0x250)
[] (device_del) from [] (usb_disable_device+0xa0/0x1e4)
[] (usb_disable_device) from [] (usb_disconnect+0x78/0x224)
[] (usb_disconnect) from [] (hub_quiesce+0x4c/0x90)
[] (hub_quiesce) from [] (hub_event+0x354/0x108c)
[] (hub_event) from [] (process_one_work+0x1ec/0x414)
[] (process_one_work) from [] (worker_thread+0x38/0x594)
[] (worker_thread) from [] (kthread+0x10c/0x124)
[] (kthread) from [] (ret_from_fork+0x14/0x3c)
—-[ end trace 7dd7e072efba8dab ]—-
r8152 1-1:1.0 eth0: set_registers -110
r8152 1-1:1.0 eth0: intr_urb submit failed: -19